Creation PCUT Cutting Plotter Support Requests

Support and help for Creation PCUT cutting plotters.

740 topics in this forum

  1. Cutting too small

    By TurboRGV,
    • 0 replies
    • 1,186 views

  2. SIGNBLAZER CANT DETECT CUTTER

    By SIGNMAN,
    • 3 replies
    • 1,530 views

  3. Where does this wire go on carriage?

    By KeystoneChuck,   
    • 7 replies
    • 2,248 views

  4. CTO630 "working laser" on LCD when sending commands from PC

    By daynj,
    • 5 replies
    • 7,160 views

  5. Text Has Wierd Outcroppings? Tracking?

    By Watson91,
    • 6 replies
    • 1,287 views

  6. Is this an Offset Problem?

    By Topper,
    • 6 replies
    • 1,769 views

  7. Strange when peeling back application tape

    By fedjastacey,
    • 7 replies
    • 1,879 views

  8. PLEASE HELP ME!!!!

    By KeystoneChuck,   
    • 12 replies
    • 2,107 views

  9. Feed rollers not turning

    By dezertracer13,   
    • 3 replies
    • 2,144 views

  10. CT630 not plotting- goes to the left

    By Ant,   
    • 1 reply
    • 2,176 views

  11. HELP...my vinyl cutter is putting knicks in every letter.

    By kristidawn,
    • 21 replies
    • 6,462 views

  12. creation pcut0630 wont. contour cut

    By brent1972,
    • 3 replies
    • 1,503 views

  13. windows 7 thinks cr1200 is a gps camera.....major help needed

    By rickster,
    • 1 reply
    • 1,511 views

  14. Motherboard help

    By fcfinishes,
    • 1 reply
    • 1,294 views

  15. PCUT Reboots in middle of cut

    By RocketRollinSX,
    • 4 replies
    • 1,633 views

  16. blade holder solenoid not working

    By fcfinishes,
    • 5 replies
    • 3,048 views

  17. Creation CT1200 PROBLEM

    By vladonni,
    • 4 replies
    • 10,770 views

  18. pcut 630 cutting shapes fine, just not closing all of them

    By airexpress,
    • 1 reply
    • 1,243 views

  19. SignBlazer not talking to PCUT 630 (settings issue?)

    By Azonic,
    • 7 replies
    • 5,219 views

  20. CREATION P-CUT CS630 CUTTING TOO DEEP

    By kimmy123,
    • 10 replies
    • 3,873 views

  21. stopped stoppedworking

    By peteblade,
    • 4 replies
    • 1,306 views

  22. Creation PCut CS630G SD Card reader not working

    By maciek,   
    • 5 replies
    • 1,496 views

  23. Cutter just "stops"...

    By plbrooks,
    • 12 replies
    • 1,748 views

  24. PCUT CTO630 - Carriage arm/blade stays in cutting position after job?

    By Rob36,
    • 4 replies
    • 1,944 views

  25. Computer keeps saying USB disabled because device drawing too much power

    By ego10,
    • 2 replies
    • 1,583 views