grumpysod 1 Posted September 30, 2010 i sand blasted this mirror from the back, covered back of mirror with white vinyl to make it stand out, then re-assemble the mirror, i used standard vinyl as a mask, it was a bit fussy to weed, but got there in the end, hope you like it Grumpy Share this post Link to post Share on other sites
bayotle 26 Posted September 30, 2010 Etching mine on the front, hope it turns out half as good! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted September 30, 2010 very nice Share this post Link to post Share on other sites
xJoey Dubsx 42 Posted October 2, 2010 Can't wait to get to toy with sandblasting, just need to get my sandblaster down from the loft. Share this post Link to post Share on other sites
SeeJaysPlace 476 Posted March 22, 2011 i sand blasted this mirror from the back, covered back of mirror with white vinyl to make it stand out, then re-assemble the mirror, i used standard vinyl as a mask, it was a bit fussy to weed, but got there in the end, hope you like it Grumpy What do you use in side your sandblaster to etch glass Share this post Link to post Share on other sites
gozo 4 Posted March 23, 2011 Did it take you more time to weed than to blast? GOOD JOB. Share this post Link to post Share on other sites
Namchief 1 Posted May 27, 2011 grumpysod, I believe your in the UK would you be interested in doing a mirror my design and sending it to a friend at Oxford University. I would do it but doubt it would make it to him without breaking. This would not be for a little while as I am still working on the design. Eric Share this post Link to post Share on other sites