Leaderboard

Welcome, Good luck. Make sure you put a ground wire on that cutter, cutter to stand. A lot of static comes from vinyl and you can fry the z-chip on it. That cutter has very limited memory, static problems, tracking problems. Should have stopped here first and read. We would have done our best to steer you to a better cutter with less problems. Anything above the MH would have been a better cutter. The MH is considered a bottom of the barrel cutter.

Not many of us have any experience using the home craft cutters ( Cricut, Silhouette, Brother) or their programs so it's hard to answer your question.

I figured as much. Would be awesome to lay in 3 colors and cut once though. The decal looks great on the car though.

Cut at once as in load several colors into the machine and have one cut file? Not happening, or at least not very effectively. You can cut weed and then either install in layers or layer then install all at once. My experience has been if they overlap there tends to be more bubbles when pre-stacking but when each color layer has it's own space with clear space between each layer it is great. If the application is going on a compound curve then definitely worth pre-layering and just put up with the bubbles. They can be popped and/or chased out if they are of any size. The super tiny ones will usually disappear after a few weeks of expansion and contraction. As you gain experience you'll have less bubbles. I know I really sucked at first but practiced and got better. Still a newb compared to a lot of those pro's out there.

Welcome from Baltimore.

Welcome from Idaho.

Hello and Welcome from Florida.

Welcome from Michigan