Leaderboard

  1. crome

    crome

    Members

    • Points

      3

    • Content Count

      85

  2. Dakotagrafx

    Dakotagrafx

    Super Moderators

    • Points

      2

    • Content Count

      21,363

  3. Jburns

    Jburns

    Members

    • Points

      1

    • Content Count

      726

  4. Wildgoose

    Wildgoose

    Super Moderators

    • Points

      1

    • Content Count

      6,515

Popular Content

Showing content with the highest reputation on 12/24/2017 in all areas

  1. 3 points
    crome
    I had an order for two "America" themed rod builds this week. I started with building the grips out of 8# expanding foam, shaped on the lathe and then covered them with e-glass. After the grips was built, I dipped them in a "Thin Blue Line" flag pattern. Once glued to the blanks, I did all the thread work and used Oracal 651 to put stars and names on the rods. The 1st rod is a split grip inshore flounder rod. The second rod is a full grip sheepshead build.
  2. 1 point
    Dakotagrafx
    generally if you buy a new cutter it will come with current software - with all of uscutters plotters you can now chose between vinylmaster and scalps - with vinylmaster being preferred in my opinion. Welcome aboard
  3. 1 point
  4. 1 point
  5. 1 point
    Cal
    Welcome aboard Tanya, Cal
  6. 1 point
  7. 1 point
    slice&dice
    Tanya, whazzup! What program are you running for cut/design? What kind of workspace are you set up in?
  8. 1 point
  9. 1 point
    hhsg
    Hi Tanya. Welcome from Indiana
  10. 1 point
    Primal Decals
    i use scalps 4 pro ,and as everyone always sees me post that i like SCALPS very much.An offset can cause this and or bad trace as Dakotagrafx said.Ive seen it before, If you have any questions with SCALPS send me a message and i will help you out.. Here is the settings for scalp..Your not the first one to have this issue with the settings being wrong.