Karo 0 Posted March 30, 2019 Heys all, greetings to the forum. I'm Karo and just got my first cutter, the Laserpoint 3. Already upgraded software for my next cutter, been reading about how much quieter the servo motors are, than in my LS3. Learning everyday with this machine and enjoy it:). Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 30, 2019 Welcome from Michigan Share this post Link to post Share on other sites
slice&dice 2,450 Posted March 30, 2019 BonJour. Quick question --- have you used any of the installed graphics that are provided within VinylMaster? Share this post Link to post Share on other sites
haumana 1,220 Posted March 31, 2019 Aloha! Welcome to your new addiction. Share this post Link to post Share on other sites
Karo 0 Posted April 1, 2019 Slice, I have not to be honest. I upgraded to DSR to support as Haumana says, my new addiction;). Share this post Link to post Share on other sites
Cal 393 Posted April 2, 2019 Welcome aboard Karo, you have found the best place on the interwebs for help and tips. 1 Share this post Link to post Share on other sites