esims1970 0 Posted September 25, 2013 Hello, Could somebody please help me. I just bought a Laser point ii cutter. and I trying to cut my images out for my t shirt. I have coreldraw, and illustator, could somebody tell me out to contour the design to cut out on my cutter. Share this post Link to post Share on other sites
slice&dice 2,450 Posted September 25, 2013 What cutting software are you using? Share this post Link to post Share on other sites
jaybyrd 3,770 Posted September 25, 2013 If using scalp call uscutter and see if you can get tech support to walk you through it. Almost everybody who's ever posted that they got it working did it with the help of uscutter support. I do it all the time but my way is definitely not the easiest. Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted September 26, 2013 Hello and welcome Share this post Link to post Share on other sites
dwp99 283 Posted September 26, 2013 Hello and Welcome from Florida. Share this post Link to post Share on other sites
sleeveofwizzard 104 Posted September 26, 2013 Welcome to the forum. Like Slice and Jay are talking about software used for the actual cutting instructions to be sent to the cutter. Corel and Illustrator are great design software but they can not communicate with your cutter. Sure Cuts a Lot Pro (SCALP) is the current supported software available from USCUTTER but they also offer a free program called Signblazer. This is available to download for free from the support section. 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted September 26, 2013 hit n run?Member Since Yesterday, 05:45 PMOFFLINE Last Active Yesterday, 05:50 PM Share this post Link to post Share on other sites
jaybyrd 3,770 Posted September 26, 2013 Impatient for help. Or just too busy to check in for his answer ? Share this post Link to post Share on other sites