carlos001 0 Posted March 5, 2013 Hi guys i am new to the forum game this is my 1st ever post so i could do with a bit of help with my cutter as i cannot get it to connect with my windows 7 computer its a liyu sc1261 it will connect ok with a xp laptop and works fine but when connect to my other it shows its in com8 but when i try to use sign blazer and set it up there is no com8 port listed can anyone out there shine a light on the matter thanks again in advance !! Share this post Link to post Share on other sites
dwp99 283 Posted March 5, 2013 Hey Carlos, I am not familiar with sign blazer but I'm sure someone will come along shortly with some suggestions. Just wanted to welcome you to the forum. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 5, 2013 if using the usb did you remember to install these drivers on the win 7 machine? - I am guessing you are using serial since you mention com8 though http://support.uscutter.com/index.php?/Knowledgebase/Article/View/202/60/01-mac--windows-driver-uscutter-mh-mk1-sc-pcut-laserpoint-and-copam Share this post Link to post Share on other sites
slice&dice 2,451 Posted March 5, 2013 Welcome, carlos. Try com4. Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted March 6, 2013 Hello and welcome Dan Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 6, 2013 welcome from Indiana Share this post Link to post Share on other sites
Rodger 527 Posted March 6, 2013 I can't remember exactly ( Jay will know ) , but SignBlazer needs to use a port under 4 or 5 from my memory . I use a serial to serial cable & all I have to do is set the ports to Comm 1 . Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted March 6, 2013 Welcome Carlos from the land of beer. Cheese and the Green Bay Packers. Share this post Link to post Share on other sites
