Search the Community

Showing results for tags 'blank screen'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Welcome to USCutter
    • Shop Online
    • Customer Support
    • Information For New Equipment Owners
    • Website and Company Feedback
  • Equipment Discussion & Support
    • Vinyl Cutters
    • Heat Presses
    • Competitor Cutter Help
    • Printers
    • Laminators
    • Engravers
  • USCutter Community
    • Community Rules & Announcements
    • Introductions
    • General discussion
    • Show your work
    • Instructional Contributions
    • T-Shirts and/ or Garments
    • Sublimation
    • Business Practices, Sales and Pricing, etc.
    • Mac Users Board
    • Pre-sale questions
    • Off Topic Section
  • Software Discussion & Support
    • VinylMaster CUT, LTR, PRO & DSR
    • Sure Cuts A Lot Pro
    • Signcut
    • SignBlazer
    • Flexi
    • Corel Draw
    • Adobe Illustrator
    • Inkscape
    • Other Software Programs
  • Material Discussion
    • Vinyl
    • Other Materials
  • Feedback Section
    • Criticism and Complaints about USCutter
    • USCutter Equipment Feedback or Suggestions
  • Graphic help and requests
    • General Help
    • Vectorizing
    • Graphic Requests
    • Fonts

Find results in...

Find results that contain...

Date Created

  • Start


Last Updated

  • Start


Filter by number of...


  • Start





Website URL







Found 2 results

  1. So I was cutting a piece of vinyl and the cut messed up and I had to pull the vinyl out because it was jammed when I went to cut the sheet again it would read it was cutting on the computer but nothing was happening with the cutter I checked the cutter and there was a blank screen I tried resetting it and it would reset display the product name as It does and go blank again I have tried everything I know to do
  2. So I bought this guy second hand and it'd been sitting in a garage for a good while. When I got it home and setup, I realized that at some point mice had made a home in the side panels. They chewed through a few of the different wires. Before I could do anything, I had to replace the fuse line, but that got it working(ish). The control panel still needed work, but for the time being I could run it with default settings. Recently I finally got around to buying a replacement screen, 16 pin cable, and a 14 pin cable and got to work on the display. The control panel works now; however, the display is still not working. It turns on, but only if the connection to the motherboard is just right, and the screen is completely black aside from a single solid line through the middle. I'm at a standstill on it now. I can't think of anything else. Anyone have any ideas? P.s. it is the same whether the USB is connected or not, and I've tried every port and two other laptops all running windows 10.