Leaderboard

  1. soundmasterx

    soundmasterx

    Members

    • Points

      2

    • Content Count

      35

  2. MZ SKEETER

    MZ SKEETER

    Members

    • Points

      1

    • Content Count

      17,529

  3. mabscotthandyman

    mabscotthandyman

    Members

    • Points

      1

    • Content Count

      4,675

  4. cowboy_1_831

    cowboy_1_831

    Members

    • Points

      1

    • Content Count

      166

Popular Content

Showing content with the highest reputation on 01/16/2013 in all areas

  1. 2 points
    soundmasterx
    Here is a real quick vector version... You will probably have to do some cleaning up... I didn't really proportion anything out (just eye balled it). Hope that helps https://www.dropbox.com/s/jkt2v7xxury8tmb/sfat.jpg https://www.dropbox.com/s/7554c5m5u0bwun0/SFAT.ai
  2. 1 point
    Promise
    Made this decal yesterday for my step daughters nexus 7 case. Took about a half hour to make the vector and thought it was too cool not to share. I recommend anyone with kids should grab it. grumpy_cat.eps
  3. 1 point
    Lady_VI
    He just delivered my new Graphtec CE-6000 (and he is kinda cute LOL). Guess I'll be busy for awhile getting this all figured out & up and running. Sure looks alot different than my Copam.
  4. 1 point
    WrestlingWear
    Here is some gear I made from WWE Wrestling star Evan Bourne. I created his outfits in the photos. Can be seen on national television, magazine covers and photographs, even had a wrestling figure that is for sell world wide at walmart wearing the gear I made. I have done multiple sets of the gear for him.
  5. 1 point
    MZ SKEETER
    Congrats Lady_Vi, Your the first person I have seen that purchased the new Graphtec CE6000, You can never go wrong with a Graphtec. Good Luck , you will love it,,,
  6. 1 point
    xpaperman
    Congrats on the new cutter!
  7. 1 point
    KINGRUPERT
    heat transfer vinyl 100% ploy mma shorts " first paying customer" watch your heat settings, i have a manuel heat press not digital had a close call on over heating!!! but all and all not too bad
  8. 1 point
    cowboy_1_831
    I just use any scrap that the design will fit on. An easy way to remove it is by using hot water, comes right off no problems.
  9. 1 point
    mabscotthandyman
    From what you described I would be between $250.00 and$300.00 I don't do the sq. Footage estimates I go by the job and perceived time and material ,overhead and profit . Make sure that you clean the window super good and use a razor blade to get off all old glue and residue from the old lettering or you will have a mess hope this helps . Good luck Dan
  10. 1 point
    mark-s
    Inkscape is free. mark-s