jbass09 0 Posted March 28, 2011 I hope this is an easy answer, but I have the ce5000-60 and I am using rolls of media. After hit enter when it says "load media", it just keeps unrolling my media. It does not always roll back into position so it can start cutting. It just unrolled my media 3 times. Any ideas on how to stop this from happening? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 28, 2011 change your setting to roll - not page - it is trying to find the end of the page . . . Share this post Link to post Share on other sites
jbass09 0 Posted March 28, 2011 change your setting to roll - not page - it is trying to find the end of the page . . . I have no clue why the setting changes sometimes, but I should have known better. That was an easy fix. Thanks! Share this post Link to post Share on other sites
HFE 0 Posted February 17, 2015 Where do you go to change this setting? I keep having the problem of the entire roll unrolling when first turning the plotter on and can't even find the option to change from 'page' to 'roll' anywhere! Thanks for the help! Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 17, 2015 its the first option when you turn the plotter on - you select then press enter - page or roll . . . .also make sure your sensors are clean where it reads the beginning and end of the vinyl 1 Share this post Link to post Share on other sites
skarekrow 1,842 Posted February 17, 2015 QUOTE> "Where do you go to change this setting?" After loading the media, the up/down arrows change the selection through "Roll 1", "Roll 2", and "Sheet" 1 Share this post Link to post Share on other sites
HFE 0 Posted February 17, 2015 Thanks so much for the help guys, problem fixed! On my plotter - CE5000-60 - it only has the "Roll 1", "Roll 2", and "Sheet" options as skarekrow alluded to. I kept looking for "Page" somewhere all afternoon yesterday haha I'm not sure what what the difference between Roll 1/2 are, but I put it on Roll 1 and it declined to unroll the vinyl i was using into the other room...for the first time in forever! Thanks again for the quick responses! Share this post Link to post Share on other sites
pshawny 410 Posted February 17, 2015 It should be, Roll 1: Starts at beginning of roll Roll 2: Starts at current position 3 Share this post Link to post Share on other sites
jaybyrd 3,770 Posted February 17, 2015 and as you found out sheet measures the whole piece. We've all done it 1 Share this post Link to post Share on other sites
skarekrow 1,842 Posted February 17, 2015 Make you wish you had a catch basket when it unwinds to whole roll on the floor and static loads it up with all the dust and crumbs you should have swept up yesterday... Ask me how I know. 4 Share this post Link to post Share on other sites
Beronica 0 Posted April 24, 2019 Hey, I have the ce6000-40 plus cutter & I use vinyl...I put it in & select sheet because all I have is a sheet...and it roll the vinyl back out every time...then I turned off the media sensor...it cut the design & then spit the vinyl out instead of holding it when it’s done...does anyone know what I need to do? Share this post Link to post Share on other sites
mfatty500 454 Posted April 24, 2019 Try changing the setting to roll 1 1 Share this post Link to post Share on other sites