Darbrown 0 Posted September 21, 2012 Hello everyone! We recently purchased a plotter with hopes and dreams of doing stencils...Not so much. We have almost used all of the mylar we purchased though! YAY! Unfortunately it's all trash. Live and Learn. We look forward to learning from everyone and hopefully ya'll can help us realize our dream! LOL! We work during the day and try to figure out the plotter at night. We have a small country gift shop with 95% of our merchandise being hand-made. Our thought process for purchasing the plotter was to enable us to have a quicker turn around time on our custom ordered signs and to save us some money by allowing us to create our own stencils. Not much else to say about us except...Help! Share this post Link to post Share on other sites
strycnine 23 Posted September 21, 2012 Welcome to the fo! I'm also from GA Share this post Link to post Share on other sites
slice&dice 2,450 Posted September 21, 2012 Hi Ya'all -- While you cry out for Help, the details of the problems you're encountering are too sketchy for us to assist. What you might want to do, is start a new thread in the Forum section that best matches what's going wrong. Is it Software related? There are topics for major programs (SignBlazer?) If it could be hardware related, try Equipment Discussion & Support. And lastly, perhaps this is even an issue with the "mylar" you're using. http://forum.uscutte...ther-materials/ Share this post Link to post Share on other sites
Jay2703 704 Posted September 21, 2012 Welcome to the forum. Where are you located? Share this post Link to post Share on other sites
piscespokerbrat 80 Posted September 21, 2012 Jay, they are near Atlanta! Welcome to the forums Darbrown! Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted September 21, 2012 Hello and welcome . There is a ton of information on here check the threads and read the post and answers to match the problem / problems you have encountered and we are always here to help there are some knowledgeable folks on here and are always happy to assist when possible . List your problems and we will try to alleviate it for you . Good luck Dan Share this post Link to post Share on other sites
Darbrown 0 Posted September 22, 2012 Thanks everyone, Yes we are located between Atlanta and Macon, GA. Thanks Slice&Dice I will do that. Share this post Link to post Share on other sites
knucklehead 530 Posted September 24, 2012 Hey, and Welcome. Right around the corner from ya at Lake Jackson. The mylar sucks to cut. Share this post Link to post Share on other sites
Darbrown 0 Posted September 25, 2012 We are beginning to see this Knucklehead and thanks for the welcome! Share this post Link to post Share on other sites