arfdltr6 0 Posted April 1, 2012 Had my cutter for a little while. Any advice will be helpful. Share this post Link to post Share on other sites
Rodger 527 Posted April 1, 2012 "Had my cutter for a little while. Any advice will be helpful." Do not look directly into the Sun , Never spit into the wind , Don't pull the mask off the Lone Ranger , Don't tug on Superman's cape & Don't EVER mess around with Jim ... Share this post Link to post Share on other sites
arfdltr6 0 Posted April 1, 2012 Thanks, I will keep that in mind!! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 2, 2012 Had my cutter for a little while. Any advice will be helpful. ALL the great advice you need, has been listed ump teen times on this forum, my ADVICE is to take time... and read it!!! 1 Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted April 2, 2012 Like Skeeter said read and research a lot there is about any thing you need to know on here. Before I bought my cutter I had lurked and read many how to post and newbie questions and by the time I got my cutter within 30 minutes I was cutting vinyl . A lot of good knowledgeable people on here willing to assist anyone willing to research and try . Good luck . Dan Share this post Link to post Share on other sites
livinloudgraphics 39 Posted April 4, 2012 share some of your work (esp files) of this stuff its great Share this post Link to post Share on other sites
vrpro 19 Posted April 6, 2012 Great work.. Your off to a good start Share this post Link to post Share on other sites
