Search the Community
Showing results for tags 'linux'.
Found 2 results
14" MH-365 Cutter
manikinxvx posted a topic in MH Series Vinyl CuttersHas anyone recently gotten an MH series cutter to fully operate under Linux? All of the information I was able to find was more than a decade old. I am most specifically looking for information on the 14" MH Vinyl Cutter(SKU: REMH365), as that one is not listed in the drivers in Inkcut; only MH-721 and MH-1351 are in the list. Does other software — besides inkcut — work better for this? This is entirely new territory for me, with regard plotter cutters. Thank you in advance, manikinxvx
Latest FTDI Drivers For All OS's
PixelPusher posted a topic in Copam Cutting Plotter DiscussionHopefully this becomes a sticky but the latest FTDI (Future Technology Devices International Ltd.) VCP (Virtual COM Port) drivers for both the COPAM and IOLINE line of cutters (it's possible more cutters use the FTDI drivers too and if so, then these will work for those cutters also) available on Windows, Mac and Linux (More operating systems available on their site. All versions including 32-bit and 64-bit) can be downloaded at http://www.ftdichip.com/Drivers/VCP.htm Be sure to look at the far right Comments Section of the table to find the link named "Available as a SETUP EXECUTABLE" to download to have the easiest way to install the drivers. There are installation guides for all OS's too. Note: FTDI VCP drivers work for all Copam and Ioline Smartrac series of cutters. These drivers are constantly updated. Check back occasionally to refresh your drivers.