kmorenor
-
Content Count
22 -
Joined
-
Last visited
Recent Profile Visitors
487 profile views
-
Hello, both the old ant the new one fit in the rail the same way, I checked, both sides of the rail and the screws are real tight, wouldn't know what could cause the carriage to be higher than it should.Does any of you help with a manual of how to dismantle it?
-
Well it's exactly the same, just that the new came with a laser. I compared them and they're the same size, they fit in the rail. And I asked for a MH 871 MK and that's what arrived.
-
Hello, It doesn't seem to be something keeping the holder to come down. As I said before, the problem is the pressure that it makes. Its too low. No matter thah it's set on maximum.
-
Sorry, yes the cutter is on.
-
Yes, the carriage is new, hoping that the old one was defective. What can I look for on the rails? They seem to be well leveled, well lubricated, I clean them often.
-
Hello friends, thank you all for your replies, I'm still working on the cutter. Send you a video so you can see what happens. Bye. VID_20200818_174438.mp4
-
Hello, that's the way it came. Just bought it.
-
Hello, yeah, if I move it down, it can go lower. Hello, no, I just came to work, put a sheet of vinyl for a car decal, and It just wouldn't cut it. Just left the mark, but didn't go through the material. I changed the blade, but didn't work. And so and so. Could be a board problem? By the way, here's the new carriage.
-
Hello, no, before the problem, the blade barely showed. And the cutpress was always set on 90~120 aprox. Just someday It wouldn't cut hard enough.
-
Hello, the cutter worked for me fine until that problem. At least 3 years, no problem. This is last year.
-
Good afternoon friends, I'd like to ask you a question. Recently, I bought a new carriage for my MH 871 MK2, and I realized it has a laser guide. But the blotter doesn't have the pin to connect it. It has the space tough . Is it possible to enable it? Thanks in advance.
-
It doesn't fit.
-
-
Hello, the cutter has been working OK, just some random day, it wouldn't cut. Like it's not strong enough to go trough the material. The blade holder is straight. There may be some tearing in the cutting strip, but the problem is about the cutting press. In the drawing it looks that the blade/pen touches the material where it is not supposed to cut. If I lift the blade a little bit, it doesn't even touch the cutting strip.
-
Doesn't fit.