gsallor 0 Posted September 19, 2023 Hello, it seems that most of the threads for copam are pretty old, well I bought one for $50 a while back and its just been sitting, I kind of wanted to try it out. I've searched through the forums a little and seen signblazer was good free software. I tried clicking a couple links but most seem to be no longer available, is that still the best free software? if so what's the best place to get it? do I need special drivers? a few posts I've seen said windows should already have the drivers. Any help to get me started would be much apricated. thanks in advance. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted September 20, 2023 You could go to Vinylmaster.com and get a current updated version of VinylMaster Cut for around $60 and be cutting today. You could also try their trial version. https://vinylmaster.software/products/cut Signcut I think, also has a trial version. The Copam has not been sold on UScutter for several years, which is why threads are old. Info for the Copam https://support.uscutter.com/hc/en-us/sections/360007369351-Copam-Vinyl-Cutter-Series Share this post Link to post Share on other sites
slice&dice 2,450 Posted September 20, 2023 There's a basic reason that old links to SBE are no longer valid: That software is no longer being supported by anyone. However, for the sake of answering your question directly, you can obtain SignBlazer HERE -----> https://www.mediafire.com/file/fjk69hgu2cpnr16/signblazer_setup.exe/file If you have specific SBE questions, please open a new thread in that category. Share this post Link to post Share on other sites
haumana 1,220 Posted September 21, 2023 Hello, it seems that most of the threads for copam are pretty old, well I bought one for $50 a while back and its just been sitting, I kind of wanted to try it out. I've searched through the forums a little and seen signblazer was good free software. I tried clicking a couple links but most seem to be no longer available, is that still the best free software? if so what's the best place to get it? do I need special drivers? a few posts I've seen said windows should already have the drivers. Any help to get me started would be much apricated. thanks in advance. Welcome to the forum! SignBlazer is a very good place to start. The link that Slice & Dice provided is still working (it's the big blue button that says "DOWNLOAD (34.26MB)". Just know that you will need to turn off your anti-virus to install it. There is not virus or malware in the .exe file, it's just that the program designer has long since passed away, and most versions that are out there have been "unlocked" so that it's no longer in Trial Ware, and you can use it indefinitely. The down side to that is that most anti-virus programs will block the installation of it. It would help us to know what version operating system you are using, as well as how you will be connecting the cutter to your computer. You can find Copam drivers here: https://support.uscutter.com/hc/en-us/articles/360037585432-USCutter-Copam-Driver-Download Share this post Link to post Share on other sites
