Chaos & Co 0 Posted May 8, 2023 I recently changed some settings to read registration marks. Now I am unable to cut anything. When I try to cut out a decal, I get; WARNING: Cursor Knife over first registration mark. Press Enter button on cutter, then click ok. I just need to cut some letters. I know it was something I changed, but for the life of me I cannot figure it out. Any and all help will be greatly appreciated. Thank you in advance. Share this post Link to post Share on other sites
slice&dice 2,450 Posted May 8, 2023 To perform a Reset on the machine, Turn on the power, at the same time press the 'up' button 3 times and follow the instructions on the control moniter. Share this post Link to post Share on other sites
Chaos & Co 0 Posted May 9, 2023 I have performed the reset and I still get the warning. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 9, 2023 Put a pen in your blade holder, put some paper in the machine, go ahead and push the ENTER button and OK, Let it do it's thing. Then see what happens. You have a pause button. Share this post Link to post Share on other sites
Chaos & Co 0 Posted May 10, 2023 I was able to getting cutting again. I ended up uninstalling all software and drivers and reinstalling everything. Share this post Link to post Share on other sites
