midwestmomm 3 Posted October 5, 2020 kash 222.eps Quote Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 5, 2020 I don't know what your doing, this is what is on the file that you sent. That's it. I have to leave,,, Quote Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted October 5, 2020 other than needing a weld it looked good to me kash 222.eps Quote Share this post Link to post Share on other sites
midwestmomm 3 Posted October 5, 2020 2 minutes ago, Dakotagrafx said: other than needing a weld it looked good to me kash 222.eps 2 minutes ago, Dakotagrafx said: other than needing a weld it looked good to me kash 222.eps it's too large to cut Quote Share this post Link to post Share on other sites
midwestmomm 3 Posted October 5, 2020 I appreciate everyone's help very much!!! I will figure something out, probably just choose a different font. Thanks again! Quote Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 5, 2020 I imported that same kash222.eps into Vinylmaster demo and got the same picture as I posted above. I can see a dotted line box going above the top and to below the bottom of that design that you have posted. That is your extra space. I would just start over and make a new file. Quote Share this post Link to post Share on other sites