trsest 2 Posted January 22, 2018 Hi, I have found as I get to the end of a roll the edge of the vinyl catches on some of the edges on the machine. This is not the side edges but the front as it goes back and forth. The edge of the ruler seems to be the worst. This causes the material to rise up and get cut when it isn't supposed to. When the roll is newer the bend is not as bad and it doesn't catch. I can put tape on the machine but that defeats the purpose of the ruler. Any suggestions?? Share this post Link to post Share on other sites
Go-C Graphics 856 Posted January 22, 2018 Simple answer would be to use clear packing tape. That's what I did. Share this post Link to post Share on other sites
darcshadow 1,626 Posted January 22, 2018 same here, just used some clear scotch tape. Share this post Link to post Share on other sites
Primal Decals 621 Posted January 22, 2018 lol Same here Share this post Link to post Share on other sites
trsest 2 Posted January 23, 2018 LOL - well when I was thinking about it I was using blue mask so my mind went to blue masking tape.......... Clear never entered my mind. 2 Share this post Link to post Share on other sites
darcshadow 1,626 Posted January 23, 2018 Some times the simplest solutions are overlooked the easiest. 2 Share this post Link to post Share on other sites
haumana 1,220 Posted January 24, 2018 7 hours ago, trsest said: LOL - well when I was thinking about it I was using blue mask so my mind went to blue masking tape.......... Clear never entered my mind. I use the blue painters tape. It's been a permanent fixture on my cutter. Share this post Link to post Share on other sites