ddonley 0 Posted January 5, 2016 I have just purchased the US Cutter SC Plotter. and Sure Cuts A Lot 3. The cutter is not cutting the right direction. I am cutting "Growing in Grace". It is 15 inches in Hieight and 120 inches long. It wants to cut it across the vinyl. I have changed direction with my mat and it does not make a difference,,,, cuts the same either way. Not sure what I am doing wrong Share this post Link to post Share on other sites
Wildgoose 4,200 Posted January 5, 2016 I am not a Sure Cuts a Lot user (SCALP) but you might try rotating the actual words. 1 Share this post Link to post Share on other sites
George2014 6 Posted January 5, 2016 When you click cut button the window shows you the preview and there's an arrow that shows direction of the vinyl. Also do not use wysywig mode. Share this post Link to post Share on other sites
busterbay 326 Posted January 5, 2016 See if this helps: 1 Share this post Link to post Share on other sites
Primal Decals 621 Posted January 6, 2016 See if this helps: Make sure the arrow on the outer edge of the mat board design is facing the correct way .The arrow points which way the material is going thru your cutter and as bustbays image as well. there shouldnt be any problems after that unless something else is wrong.. I use scalps 4 pro to cut and desing in Ai cs6 Share this post Link to post Share on other sites