JS252 0 Posted March 9, 2015 Can anyone tell me when I make a cut on my USCutter 871 the finish point doesnot connect with the start point. It leaves a small gap. The gap is not even a half of mm, its bout a .15mm gap. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 9, 2015 Look for OVERCUT in your cutting software. I don't use SCALP Share this post Link to post Share on other sites
JS252 0 Posted March 9, 2015 I use sure cuts 3, I have changed my speed and the overcut a couple different times Share this post Link to post Share on other sites