diamondback 1 Posted March 24, 2014 Hello all! I am new to vinyl cutting. I recently purchased a used vinyl cutter and software. I am hoping to get it all figured out to add into my existing hydrographics business. Look forward to reading and learning from everyone Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 24, 2014 Welcome from Michigan Share this post Link to post Share on other sites
elopyam 0 Posted March 24, 2014 Hello purchased a vinyl cutter and i am very new to this world. Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted March 24, 2014 Hello and welcome you will find most anything you would want to know in this forum there are threads on about any subject pertaining to vinyl then some. Good luck Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted March 24, 2014 Hello purchased a vinyl cutter and i am very new to this world. Hello and welcome. With some reading and research you will be an old pro in no time. Share this post Link to post Share on other sites
dwp99 283 Posted March 24, 2014 Hello and Welcome to the forum. Share this post Link to post Share on other sites
kauffman21 32 Posted March 29, 2014 Welcome to the forum. I would recommend just reading through some of the "Instructional Contributions" section. I learned a lot in very short time just by reading that section of the forums. Saves you time, money, and headache if you do. There are some very informative and friendly people here that will help you. Share this post Link to post Share on other sites
JJennings 4 Posted March 30, 2014 Welcome From South Carolina... What is your location Diamondback ?? Share this post Link to post Share on other sites