sniderman 8 Posted August 5, 2013 I read on here a few months ago about people haveing problems keeping stickers on atv plastic. what was the solution to the problem? I remember somhing about cleaning area with alcohol. Is that correct? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 5, 2013 many of the low energy plastics take a special high adhesive vinyl like convex for printing to adhere correctly 1 Share this post Link to post Share on other sites
sniderman 8 Posted August 9, 2013 what is the best way to prep the plastic? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 9, 2013 a good cleaning with alcohol 1 Share this post Link to post Share on other sites
Monkey 252 Posted August 9, 2013 I try to wipe most things down with alcohol before putting any decal on it. Just gets through any other chemicals that might be sitting on the surface from other cleaners. The small alcohol wipes for minor cuts are great to throw in an install bag. 1 Share this post Link to post Share on other sites
sniderman 8 Posted August 9, 2013 Thanx guys. I will do that, I am gona just use my avery or what ever vinyl I have and replace as neened Share this post Link to post Share on other sites
sleeveofwizzard 104 Posted August 10, 2013 Dakota do you stock any high adhesive vinyl? A friend of mine has been bugging to do his Enduro. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 10, 2013 I have a roll that is only about 15" wide - that stuff is too expensive for most of what I do Share this post Link to post Share on other sites