SignBlazer and Graphtec CE-6000

[SmallSigns 23]

I've been using a Laser Point and Sign Blazer for alot of years and was thinking about upgrading to the Graphtec CE-6000 - 60.

 

Just wondering it the Graphtec will work with SignBlazer.

 

I'm too old (and stuborn) to learn new software at this point :-)

[arty-rc 718]

I know what you mean. I've been using SBE with my Graphtec since day one. No problems!!!

[SmallSigns 23]

I know what you mean. I've been using SBE with my Graphtec since day one. No problems!!!

 

 

Thanks for the info!!!

 

Great news for an old fart.

[Rob@MM 1]

I know what you mean. I've been using SBE with my Graphtec since day one. No problems!!!

 Since SBE hasnt been updated forever, which Cutter output setting are you using? 

[arty-rc 718]

In my version of SBE I use the Copam CP-2500 setting. I have had no problems at all.

[odokie 8]

I have been using SB with my Graphtec CE5000-60 and purchased the newer Graphtec CE6000-60.  Will i need to download a new driver along with changing to the Copam CP-2500 setting?  I set up and made the change to Copam CP-2500 setting but it doesn't do anything.  I cant remember what I did to set up the 5000 years ago.

Thanks for any help! 

[MZ SKEETER 4,686]

From what I have read, they are still using Copam in Signblazer,   Make sure the 6000 is on Command HP-GL language.  

[odokie 8]

Thanks MZ SKEETER.  I will see if this works.

[MZ SKEETER 4,686]

Your welcome,  If that is not the problem download the 6000 driver and do a new set up. using Copam.