soscustoms 0 Posted May 9, 2013 how do I get my cp-3500 to cut with the big plug (16pin) an not a usb? were do I find the drivers ? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 9, 2013 here is what usc has for drivers but with the serial you shouldn't need anything except what is in your cutting softwarehttp://support.uscutter.com/index.php?/Knowledgebase/List/Index/21/copam Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 9, 2013 I can't remember if that serial cable on the copam was a null modem only cable or not - maybe someone currently with one will chime in Share this post Link to post Share on other sites
soscustoms 0 Posted May 9, 2013 hmm thanks for the help but no luck yet that did not fix my prob Share this post Link to post Share on other sites
soscustoms 0 Posted May 9, 2013 the lpt cable is what am trying to use Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 9, 2013 been quite a while since I had my copam and it came with both cables - I would contact usc to find out the right one to use. as I remember I just used the usb most of the time Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted May 9, 2013 Whith the lpt cord did you pick the lpt port as output ? Share this post Link to post Share on other sites
