Greeneye80 0 Posted April 29, 2013 I have purchased a used Goldcut series 721 and I cant find the correct driver on SBE to cut. SBE is not communicating at all with my plotter. Any thoughts? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 29, 2013 from USCUTTER.com support pages http://support.uscutter.com/index.php?/Knowledgebase/List/Index/41/goldcut Share this post Link to post Share on other sites
Greeneye80 0 Posted April 29, 2013 Ok thank you. I am not sure how to unzip/uncompress the file though. It says to: Steps to Use this File: 1. Unzip/UnCompress the folder "Driver" to the desktop2. When windows asks you to select a driver - point the wizard to the driver folder on the computer3. Continue through the installation and the GoldCut driver should install. When I right clicked there was no unzip option Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 29, 2013 I didn't right click it,, I just clicked the folder,,,,you should get EXTRACT all files, I just did. Click EXTRACT all Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 30, 2013 you have to have a zip utility installed on your computer like pkunzip, sinzip, winrar etc Share this post Link to post Share on other sites