Pcrat 65 Posted September 27, 2012 anyone else have a problem with the measuring deal on the cuter catching the vinyl? Theres a small lip there, when the vinyl rolls forward it catches right there, it will push itself out, but still, I have to put like, masking tape over it so it dont catch, why didnt think catch this in the design stage lol. I know its jap crap, but still... 2 Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted September 27, 2012 The cutoff grove on my pcut catches the vinyl some times as it rolls out it comes loose . Share this post Link to post Share on other sites
Pcrat 65 Posted September 27, 2012 its handy to have that for measuring, but lower down would of been nice. but yea like i said some masking tape over it dont hurt. Oh that's what those are,, cut off grooves lol. ive been using scissors hehe Share this post Link to post Share on other sites
piscespokerbrat 80 Posted September 27, 2012 Excuse you Pcrat.. I take EXTREME offense to the term "Jap Crap." This cutter was made in CHINA.. there is a world of difference between the 2 countries, but still, if your going to be racist, do it on someone elses time!! 1 Share this post Link to post Share on other sites
MrMopar64 47 Posted September 27, 2012 You can cover it with clear tape or put a small curl in the end of the vinyl at the start of the job MM64 Share this post Link to post Share on other sites
Pcrat 65 Posted September 28, 2012 yep, curl sounds better, piscespokerbrat, Did not mean to offend you or anyone, I am not racists, just never got anything that was worth anything from there. My bad. Share this post Link to post Share on other sites