Neuromax 97 Posted April 26, 2011 I am going to order a graphtec CE500-60 in the next day or two and I am just trying to figure out what kind of software I should run. I have a WF1100 and want to be able to contour cut. Right now I am using a Copam 2500 with SB and its a great plotter but I really want that contour cut. Any suggestions would be appreciated. Thanks! Share this post Link to post Share on other sites
roxanneupnorth 106 Posted April 26, 2011 I thought Graphtecs has their own software..... 1 Share this post Link to post Share on other sites
Rodger 527 Posted April 26, 2011 IMO , starter is not much for designing . I bought it after using SB & was VERY disappointed . So was the member I sent it to . I understand about the contour cutting though . Share this post Link to post Share on other sites
Neuromax 97 Posted April 27, 2011 I don't mind designing in inkscape or corel I just would like some easy to use software for contour cutting mainly. Share this post Link to post Share on other sites
Rodger 527 Posted April 27, 2011 never had any problem cutting with Flexi . Right now , i would think Flexi is the most supported software available . Share this post Link to post Share on other sites
