final outer cut

[mailman 1]

After I finish a cut, using sign-cut my cutter cuts a box around my design, but only on 3 sides is there a setting to cut all 4 sides. I was not sure how to search for this answer. Thanks, Mark

[pogo 0]

I had the same problem with a refine mh721.  The solution was to set the driver in signcut to refine 1 hpgl.

[Dakotagrafx 7,298]

is the graphic slightly too large for it to cut the other side?

[mr300s 1,272]

is the graphic slightly too large for it to cut the other side?

I was thinking the same thing but I think that only happens with the graphtec?

[hockeygirl 30]

If you're talking about the weeding box, signcut pro doesn't finish the final side of the box if you're only cutting 1 of. It'll do it correctly if you're cutting multiple.

[CRD 9]

The weeding box always closes four sides as a rectangle if selected to do so.

One side open never seen even if I cut one single job or multiple in line cutterwide.

Paco

[mailman 1]

Thanks everybody

[JoeBlow 5]

Paco is correct, I think you have your vinyl width set too wide.

Joe

[CRD 9]

Mailman,

Does it work as intended or not.

Paco

[Kimon 1]

Which side is incomplete as you face the cutter, right or left, top or bottom?

[Cable Tech 0]

I have Flexi and MH-721 and mine doesn't finish the bottom weed line of the box either. 

I'm sure there is a fix but I haven't messed with it. I'm just happy my cutter is cutting properly with no major problems...