mailman

Thanks mfatty I will give this a try. Thanks again, Mark

Cannot get contour or border to cut inside of letters. I can set contour around font but not the center such as on R or O. Thanks, Mark

Thanks for all the help. Mark

Thanks again for all your help. Mark

Thanks MZ SKEETER I gave it try, I set the size of test box to cut a 2"x2" square at 100% it cut a box 8"x8" . I reduced the percent to 25% and it did cut 2x2 square. My device units per inch is set at 1016 should I reduce this to 254? Thanks, Mark

My image is cutting about 4 times the size of original image. I am not sure how to calibrate size. Is there a factory setting that is standard in the device units per inch. Mine was set to 1600 units per inch.Thanks, Mark

THANKS. MZ SKEETERK. Mark

I upgraded to vinylmaster ltr , for the life of me I cannot figure out to access extra fonts. I did download the extras file. Thanks, Mark

Try tree silhouettes

Thank you very much for your help, I really appreciate it. Thanks again, Mark

Could someone help me with a default font, I choose a font , click on my page and the font reverts to arial 24pt. Any help will be appreciated . Thanks, Mark

Thank you both very much I really appreciate your help. Thanks again, Mark

probably should know this, what file type to use when e-maiingl a CDR file to someone without Corel draw. Just want include in body of e-mail. Don't know how to convert to jpeg. Can I send Bitmap and at what resolution? Thanks, Mark

Thanks Mz Skeeter, sorry it took so long to say thank you for your help, Mark

Thanks Mz. SKEETER, the job is cutting fine, I thought the cut would begin at the origin point, bottom right if I sat that as the origin point and feed as it cut, I guess things are OK. Thanks again, Mark