mailman 1 Posted November 16, 2009 I feel stupid asking this, which hole does the cutter holde body go in on the carriage , I have two, does it go in the rear or one closest to the locking screw. Thanks Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 16, 2009 blade to the rear, pen to the front Share this post Link to post Share on other sites
Guest HowardI Posted November 16, 2009 I always use the back, blade or pen. But that's just me. Howard Irwin Support Specialist US Cutter 425-481-3555 888-298-8143 - Option 2 Share this post Link to post Share on other sites
BannerJohn 1,324 Posted November 16, 2009 I always use the back, blade or pen. But that's just me. Howard Irwin Support Specialist US Cutter 425-481-3555 888-298-8143 - Option 2 me too. I was always told that the front was for when you CUT THROUGH something, like card stock. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 16, 2009 I always use the back, blade or pen. But that's just me. Howard Irwin Support Specialist US Cutter 425-481-3555 888-298-8143 - Option 2 me too. I was always told that the front was for when you CUT THROUGH something, like card stock. +1 On my 1351 the front was over the softer part of the strip to cut thru not over the cutting strips hard part. If I remember right it was more like a velor material there Share this post Link to post Share on other sites
mailman 1 Posted November 18, 2009 Thanks everybody, Mark Share this post Link to post Share on other sites