grinding noise, i think i fixed it.

[lynnpromotions 0]

My laser point started grinding and the rollers would seem to bind. I think I fixed the problem. One of the screws on the roller seemed to stick up a little and it was loose. I tightened it down and the problem seemed to go away.

Just a note in case any one else has that problem.

[MZ SKEETER 4,709]

:thumbsup:

[lynnpromotions 0]

Ok, we have been cutting for hours now without an issue. I think that was it.

[BannerJohn 1,324]

thanks for posting this! It could save people a lot of time and trouble.

[Dakotagrafx 7,297]

:thumbsup:

[Guest HowardI]

It is rare but has happened a couple times.  Great troubleshooting!

Keep up the good work and happy cutting!

Howard Irwin

Support Specialist

US Cutter

425-481-3555

888-298-8143

  - Option 2

[lynnpromotions 0]

it looks like the head of the screw was up just enough to catch on something under the covers. once i tightened it the problem went away.

[CRD 9]

Problem is covered already in the NEW BIE manual.

Paco