han7681 0 Posted October 31, 2009 hi if the line ls not smooth as shown in the photo,will the cutting edge be smooth or not? and how can i make it smooth? thanks! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 31, 2009 You could try posting the file that your trying to cut, and see if someone can look at it. and see if it is a smooth file. Share this post Link to post Share on other sites
han7681 0 Posted October 31, 2009 thanks this is the file. test.ai test.ai Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 1, 2009 I just cut the design and it cut fine using Flexistarter and a Graphtec cutter Share this post Link to post Share on other sites
MaderDesign 3 Posted November 22, 2009 It also depends on what % you are viewing the screen, images will appear jagged at certain %. Try making the object bigger and looking at it at 100% Share this post Link to post Share on other sites
Karl 0 Posted November 30, 2009 Exactly! if a line on the screen is not perfectly horizontal or vertical it will show as "bumpy" this is a screen resolution thing, you may find some improvement by increasing monitor resolution AND / OR increasing Document resolution = in Document setup or when new doc created; see attached. Default doc is 72 dpi, can be set to 300 dpi which makes a much larger file size. No matter if it is bit map or vector image, if a line is drawn with the line tool, no matter how it appears, it is straight in the vector graphic data, and that is what gets sent to the cutter. Share this post Link to post Share on other sites
