Corel Draw X4 Does Not Work with Copam 2500 Driver

[Porkchopusn 0]

I understand there is a Copam 2500 driver that works with older versions of Corel Draw.  It does not work with X4.  Does anyone know if a new driver is in the works for Corel?

[Guest kenya]

((Bump this again))

[Brandon_Davis 1]

Hey Pork... Are you trying to do a direct send via Corel Draw or are you using a cutting software plugin to work with your Copam?

[Porkchopusn 0]

I am now using Cocut, but have a problem in cutting on the Copam.  All dimensions on Copam are about 50% smaller than what cuts on the cutter.  I have the same problem with SB.  It appears that the Copam is incorrectly measuring the material.  8.5X11 inch paper is being measured at 150mmX225MM.  Have you seen this problem in the past?

[MZ SKEETER 4,709]

possibly try a different driver,, as you know it is not the software. 

[Brandon_Davis 1]

I know that SBE has a setting that corrects for size differential and I have seen people with this setting enegaged causing this specific issue.

The setting is in the setup window ... It is like size correction or something. Look for that.

[Porkchopusn 0]

I will see if I can find it. 

Jim..