harleyman 0 Posted April 20, 2009 When you buy a cutter is there a CD with it so computer will add it as new hardware Share this post Link to post Share on other sites
kenimes 42 Posted April 20, 2009 Good question...not sure. Have you asked the people who you bought the unit from? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 21, 2009 when I purchased my Seiki the only cd with it, was for the serial cable,,RS-232C, then it recognized the hardware,,, plotter doesn't have a cd.... Just serial cable and signware do.. Share this post Link to post Share on other sites
TaterNuts 3 Posted May 18, 2009 Master plotters are either parellel or Serial... at least on mine that all there is... The design program that you use can install the drivers for it... No seperate cd. Share this post Link to post Share on other sites
PBear 5 Posted May 22, 2009 some come with a doggle (?) thingy,,, it has the info on it Share this post Link to post Share on other sites
TaterNuts 3 Posted May 22, 2009 some come with a doggle (?) thingy,,, it has the info on it Dongle is a security key for software... I never seen a dongle for a plotter, that i know of anyways Share this post Link to post Share on other sites
gsxr1000 0 Posted May 26, 2009 When you buy a master it should come with a dongle usb key, the program is inside and called SignGo. Share this post Link to post Share on other sites