Search the Community

I've recently tried to 'RIP and Print' something from with FlexiPrint Avery Dennison Edition as I always do but now flexi doesn't start the ripping process. It simply stalls at "Loading..." in the production manager. Adding the job as pdf directly into the production manager results in the same stall. As well, switching the send mode to "Save to file" and saving as a .prt file results in it stalling on "Processing..." in the RIP section of the production manager. Can anyone help me solve this issue? Thanks in advance

Hi, I have an older vinyl cutter that I got from a friend and am trying to get to work. I can not get a test cut to work on the cutter which is the step i need to do before i even try to connect it to any software. The manual says if it happens I should do this The PEN MODE LED and POWER/ERROR LED blink simultaneously This flashes if the location of the pinch rollers is not correct (that is, if the pinch rollers are not positioned above the grit rollers). If DIP switch SW-9 on the CM-24 is set to ON (piece material) and material with a vertical length of 100 mm (3-15/16") or less has been loaded, or if SW-9 is set to ON and there is no material over the front and rear paper sensors. You can cancel the error by pressing the SETUP key. Refer to "3-5 Loading the Material" to load the material correctly 12:00 i have the SW-9 switch on and my piece of vinyl is 24'' long it is also positioned over the leftmost grit roller correctly according to the pictures in the manual. I watched a lot of youtube videos on this and it seems like I am doing everything right. I attached a video of me doing it in case it helps. 20200808_111053.mp4