Search the Community
Showing results for tags 'prismcut'.
Found 3 results
-
My prints are good, I’ve tried different sizes and widths and offset of the marks, but the P28 just moves to the text (usually) and then it starts beeping. Questions: does it matter where the vinyl is placed on the cutting mat? It shouldn’t as long as the carriage is set over the first registration mark. also, I have to print on 8.5 x 11, but I have the mat in the software set to 12x12 by default, because that’s what I normally cut. i am cutting two 5x5 square decals with a 3” hole in the center. How do I tell it to cut the center, too? I am telling it to only cut the color of the layer that just has the outline that I need, so it may all work if it would only recognize the registration marks. Marks are black, vinyl is glossy white under marks, but decals are blue.
-
I recently saw a vinyl cutting video where there were alignment marks across the front of the cutter. "Self," I thought, "than would be handy." So off to Amazon to see what I could find. There I found an adhesive backed 24" tape measure that was right-to-left reading. It's a great improvement over the Mark 1 eyeball I was using to align my vinyl.
-
I am trying to set up a prismcut cutter with flexi by sai, ive used flexi for years and never had an issue like this there is not an option to add it when I go to add setup, the manufacturer isnt listed has anyone else had t/his issue is there a work around? thank you
