Search the Community
Showing results for tags 'mh 721'.
Found 2 results
keloholic posted a topic in USCutter Refine Cutting Plotter DiscussionMy MH 721 Refine only will cut fine up until the carriage gets to the 9 inch incremental mark on the ruler. As it reaches the width of 9 inches it seems as if the pressure lets up and it stops cutting deep enough to make the cut. It only scratches the image on the surface of the vinyl. If I cut a small decal it is fine, but decals over 9 inches across won't cut after the 9th inch, just scratch. I have the blade as low as it will go without cutting through the backing from 1-9, but still only scratches the surface after the 9th inch. Pressure also set to maximum 600.
Can't get MH721 to close cuts, ever.
XclusiveAutoworks posted a topic in USCutter Refine Cutting Plotter Support RequestsMH721 28" Bought about 6 months ago Windows 8,7, and XP machines Latest drivers Sure Cuts a Lot Pro 3.053 USB (high quality cable) but I know, USB sucks. First month, machine was okay. It would close most cuts but sometimes would go on a fritz and start cutting all over my vinyl wasting 2-3 feet of vinyl. I stopped using the machine because of this but now recently I need to use it again. Settings are 50mm/s and 90 pressure. On standard Oracal Calandered white vinyl. Even when I use the machines "test" it will not close the cuts, at all. Leaving a good 1mm gap after each cut. Machine is grounded and I tried wiping down with one of those dryer cloths. Any ideas? I have been loosing my mind googling this.