KMCreations

Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About KMCreations

  • Rank
    Newbie
  1. KMCreations

    Vinyl Cutter Stopping Mid Cut

    Yeah, I always push RESET otherwise it rolls my vinyl out the back of the cutter.
  2. KMCreations

    Vinyl Cutter Stopping Mid Cut

    OK I will try that. It completes the cut the 2nd time and a time again after that. But usually every new cut I make it does this the first time, lately the 2nd time too.
  3. Hi Everyone, Lately my MH721 vinyl cutter has been starting it's cut and then 5 - 8 seconds into the cut it stops and I have to start the cut all over again - it's wasting a lot of my vinyl. Especially on big pieces when it goes half way down the vinyl and stops. What is going on?
  4. KMCreations

    Cutting with TWO Programs

    Hi Everyone, I was wondering if it was possible or not recommended to cut with 2 programs. I was previously using Sign Blazer Elements, but bought a new cutter and now have VinylMaster Cut. I am not familiar with VinylMaster Cut and have all of my other files on SBE. Is there a way to cut from both programs without messing anything up?
  5. KMCreations

    Cutting with TWO Programs

    Hi Everyone! I just received my new USCUTTER MH721-MK2 and it came with the VinylMaster Cut program. I was previously using Sign Blazer and I am very familiar with that program and have all of my designs on that program. I got my vinyl cutter working with the new program but was wondering if there was a way to set up my Sign Blazer and my VinylMaster Cut program to use the same cutter without messing anything up! Thanks for your time!