Mzzmccurdy 0 Posted December 5, 2014 Hey y'all I am new to this all I have set up my cutter. Installed the drivers and have yet to get a single thing to go. I am hoping to use this as a pen plotter of fashion patterns/Cutter for hard-card blocks mostly. However I am excited for all of the other prospects. Dose anyone here use their MH187-mk2 in this manner any tips would be greatly appreciated. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted December 5, 2014 Welcome from Michigan - you will need to use a cutting program like came with your cutter to cut with it - if you are trying to use it like a direct pen plotter than you would want a cutter with a true usb and not emulated like the value cutters. I have seen someone on the forum get one to plot that way but I don't recall it being reliable. you bought a device that uses vector graphics - so it won't just plot a raster file. guess more info from you is needed to help. you installed the drivers, hopefully including the emulation drivers (FTDI I believe) and then output from your vector based cutter program (scalp should have came with it) Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted December 5, 2014 Hello and welcome from West Virginia. Share this post Link to post Share on other sites
Dawn's Design 403 Posted December 6, 2014 Welcome from Mississippi.. Share this post Link to post Share on other sites
Renee S 3 Posted December 6, 2014 Welcome from Utah! Share this post Link to post Share on other sites