sweethart1711 0 Posted May 16, 2013 When I am cutting my monograms some little spots look like they have been picked or stabbed. I can't figure out what is causing them. Too much pressure? Need a new blade? Is it the font? See pictures for what i'm talking about. you can see little white spots where the vinyl is picked or looks lifted off. it doesnt look good on personalized items. some letters are worse than others. HELP please...any advice is greatly appreciated. Share this post Link to post Share on other sites
jaybyrd 3,770 Posted May 16, 2013 Was this done through a trace program because all of it looks kinda rough around the edges. Share this post Link to post Share on other sites
Jay2703 704 Posted May 16, 2013 Is your blade spinning freely in the holder? Share this post Link to post Share on other sites
jaybyrd 3,770 Posted May 16, 2013 Could you post the file you we can see if its cutter or design related. Share this post Link to post Share on other sites
sweethart1711 0 Posted May 16, 2013 This was done with Sure Cuts a lot. Its a font Ive downloaded Not a trace image Jaybird: How do I post the file I will try loosening the blade holder. thank you all for your input. Share this post Link to post Share on other sites
sweethart1711 0 Posted May 16, 2013 I played with the blade and it seems to be spinning freely. What else could cause this? Share this post Link to post Share on other sites
Jay2703 704 Posted May 16, 2013 What cutter do you have? Check that the carriage for the blade holder is on it tracks and tight. Share this post Link to post Share on other sites
MadHatterGraphix 1,258 Posted May 16, 2013 Had somewhat of a same issue convert it to curves see if changes. Share this post Link to post Share on other sites
jaybyrd 3,770 Posted May 16, 2013 save file then in post section here click more reply options and it will open with a window to browse your computer. find the file and upload. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 17, 2013 too much blade Share this post Link to post Share on other sites