xstar 0 Posted March 3, 2012 My Cutting plotter controller program messes up once in a while and i get usb error and have to reboot the cutter and software does this happen to any of you guys? xstar Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 3, 2012 My Cutting plotter controller program messes up once in a while and i get usb error and have to reboot the cutter and software does this happen to any of you guys? xstar no, mine never has , owned since '08 Share this post Link to post Share on other sites
Rodger 527 Posted March 3, 2012 no , mine never has , owned since '07 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 3, 2012 no , mine never has , owned since '07 LOL Roger,, He is referring to the Graphtec Cutting Controller. You don't own a Graphtec Share this post Link to post Share on other sites
mr300s 1,272 Posted March 3, 2012 Must have been before his morning coffee lol mine has never messed up but I usually just use the plotter for the settings as I dont change them too much Share this post Link to post Share on other sites
Rodger 527 Posted March 3, 2012 I knew he was talking about his Graphtec & specifically about his control program . I was haing fun with Skeeter .. besides , I don't drink coffee in the am .. 2 LARGE cups of hot tea with carnation condensed milk since elementary school . I drink coffee during the day to perc me up if I am dragging butt . Share this post Link to post Share on other sites
xstar 0 Posted March 3, 2012 Im not sure why, i am using a usb extension cord of 10ft and also i have different pc's that i have connected to it that have different plotter settings. I guess i could just use the plotter for settings as i also dont change the settings often. I just dont like it when im not sure what the problem is.... Share this post Link to post Share on other sites
xstar 0 Posted March 3, 2012 OK i just updated my cutters firmware to 3.70 and it seems ok so far, what firmware sre you using? Thanks xstar Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 3, 2012 the one from '08 when I installed it... LOL Share this post Link to post Share on other sites
xstar 0 Posted March 3, 2012 Which is? and what version of cutter plotter controller pls? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 3, 2012 my disc is only for the FC7000-MK-75 for 2007.. that's all the info on it. No other info on the cutting controller either. Just my cutter model. Share this post Link to post Share on other sites
markvvq 14 Posted March 3, 2012 Mine never has, owned for 2 days > Mark Share this post Link to post Share on other sites
xstar 0 Posted March 4, 2012 ok all fixed, i updated my cutters firmware to v3.70 and uninstalled cutter plotter controller v2.20 and installed v1.20, i had installed drivers from the graphtec uk site because their versions were newer. xstar Share this post Link to post Share on other sites