WRECKS 0 Posted September 10, 2008 I am experiencing chatter when the blade moves from left to right. This only occurs on straight line "horizontal" cuts. It works fine in all other directions. Right to left is ok as well. The result is a cut that looks like a perferation. This is the case with various brands of vinyl. I have tried a new blade and adjusting down force. I have very little time on this machine, so parts should not be worn out. Any help would be appreciated. Thanks. Share this post Link to post Share on other sites
haumana 1,222 Posted September 10, 2008 Try reading thru this thread and giving some of the suggestions a go. btw - to the forum. **caution: this forum has been known to cause addictive behavior. Share this post Link to post Share on other sites
kenimes 42 Posted September 10, 2008 Blade is either out too far, or not enough pressure is being used on the cutter itself. Set the Pressure to 120 or higher, and retract the blade some more. You should barely be able to see the tip of the blade sticking out of the blade holder. Share this post Link to post Share on other sites