FlexiSIGN-PRO 7.5v4-1 can I use it with my creation 630 ??

[MR kranwinkel 6]

can i use this version with my  pc creation 630 FlexiSIGN-PRO 7.5v4-1 ?

and how good is this version ??

[Guest fivestar]

If there is a driver for your cutter then yes, if not then someone should be able to post one for you.  As for how good it is, well it's almost the best version out there.  Well actually I haven't used that particular version but I use 7.6 and I'm sure there isn't any major difference between them.

[MR kranwinkel 6]

ok and how can i get the driver ??

[Guest fivestar]

Is it in you driver list in flexi?

[MR kranwinkel 6]

i checked the outputdriver but nothing w/this cutter?

[Dakotagrafx 7,297]

I have used flexi sign pro 7.6 with my 630 but can't remember if it had the driver in it or if I used the driver disk that came with the pcut

[Guest sciondrgn]

I use 7.6 as well,  Make sure you select cutter first then go through the list, The driver was on the uscutter site but I dont see any of the files listed anymore under support,

If someone doesnt havent it I can post the creation driver later when I have access to the pc its on

[kenimes 42]

The selection from Add Setup in the Production manager should be Creation PCut as the manufacturer, and CT630 DMPL as the model. If you do not have these listed as selections, copy and paste the file I have attached to your OutPut Drivers folder for Flexi.

Creation-PCut.zip

Creation-PCut.zip

[new2this 1]

Does 7.6 use a dongle

[Dakotagrafx 7,297]

the one I have doesn't

[MR kranwinkel 6]

ok thanks bro