ryan_46307 0 Posted August 20, 2008 When ever I try to plot something it will not finish the cuts. I had the same problem with SBE, but with flexi the gaps are HUGE. Like for instance it will not finish the whole back side of an "a" and it does this with every letter. Any insight? Share this post Link to post Share on other sites
mortalimmortal 7 Posted August 20, 2008 You need to adjust the offset. Heres the post with pictures to set it. http://forum.uscutter.com/index.php/topic,6537.0.html Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 I ahve my flowcontrol set on xon/xoff does that make a difference? Share this post Link to post Share on other sites
kenimes 42 Posted August 20, 2008 I would set it to Hardware for the flow control. Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 I tried that but it says it can not open the port I think. I changed the setting for the port also in the device manager and in the program. Which hard wires should be checked? Share this post Link to post Share on other sites
kenimes 42 Posted August 20, 2008 Which model cutter? Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 Creation PCut ct-630 Share this post Link to post Share on other sites
kenimes 42 Posted August 20, 2008 Have you selected the Creation PCut Ct630 DMPL? Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 Where would that be at? I have not seen anything that says that before though. Share this post Link to post Share on other sites
kenimes 42 Posted August 20, 2008 Production Manager- Setup, then Add Setup. Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 The only ones there are are ct-630 and ct-630g Share this post Link to post Share on other sites
kenimes 42 Posted August 20, 2008 Go to My Computer- Program Files- SAi- SAi Production Sutie- Output drivers folder, and remove the Creation PCut csm file, then replace it with this one. Creation-PCut.zip Creation-PCut.zip Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 Aight got it... Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 What setting do I put it at? Share this post Link to post Share on other sites
kenimes 42 Posted August 20, 2008 Not sure what you mean? Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 for the hardwire settings. Share this post Link to post Share on other sites
ryan_46307 0 Posted August 20, 2008 Nevermind I figured it out Share this post Link to post Share on other sites