ryan_46307
Members-
Content Count
25 -
Joined
-
Last visited
Never
Community Reputation
0 NeutralAbout ryan_46307
-
Rank
Member
- Birthday 01/01/1
Profile Information
-
Gender
Not Telling
-
I was wondering if there is a way to cut overlays for cars if you have a 24" plotter and you want to do a roof? Any ideas?
-
Nevermind I figured it out
-
for the hardwire settings.
-
What setting do I put it at?
-
Aight got it...
-
The only ones there are are ct-630 and ct-630g
-
Where would that be at? I have not seen anything that says that before though.
-
Creation PCut ct-630
-
I tried that but it says it can not open the port I think. I changed the setting for the port also in the device manager and in the program. Which hard wires should be checked?
-
I ahve my flowcontrol set on xon/xoff does that make a difference?
-
When ever I try to plot something it will not finish the cuts. I had the same problem with SBE, but with flexi the gaps are HUGE. Like for instance it will not finish the whole back side of an "a" and it does this with every letter. Any insight?
-
Got the dvd yesterday, but its got a big 'ol warning about not reproducing the dvd...sorry guys
-
Ok never mind then lol
-
What is the best software to use with the 630?
ryan_46307 replied to ryan_46307's topic in Creation PCUT Cutting Plotter Discussion
I would love to go with a linux machine, but nothing ever works correctly lol. It took me like a damn day to get all the drivers setup when I tried using it one time.