Guest fivestar Posted January 18, 2009 Ummmm.......not for sure, I will try to look into it tomorrow at the store and see if I can figure anything out if you don't get it figured out by then. Share this post Link to post Share on other sites
neron15210 10 Posted January 18, 2009 Thanks man. Can not wait to try it. Share this post Link to post Share on other sites
Joezeppii 0 Posted February 19, 2009 I just bought the 48" laserpoint....will this method work for that cutter? Also, what driver do I use for that cutter? I don't see USCutter listed. I have 2 different creation drivers listed. I do have flexi pro 8.1 Thanks Share this post Link to post Share on other sites
routesmith 0 Posted February 19, 2009 Fivestar, your pictures in the beginning post are not showing anymore, could you possibly repost? thanks Wayne Share this post Link to post Share on other sites
Guest fivestar Posted February 19, 2009 Fivestar, your pictures in the beginning post are not showing anymore, could you possibly repost? thanks Wayne Sorry Wayne they have been lost into cyberspace forever. My webhost had a problem awhile back and I never had a backup of them so they are gone. Maybe I get some free time I'll redo it again. Share this post Link to post Share on other sites
routesmith 0 Posted February 19, 2009 its ok Just asking Wayne Share this post Link to post Share on other sites
routesmith 0 Posted February 19, 2009 I cant believe I am almost at 1000 posts Share this post Link to post Share on other sites
Joezeppii 0 Posted February 24, 2009 Will this work with the laser pointer cutter and flexi pro 8.1? Thanks, Joe Share this post Link to post Share on other sites
JoeDirt 5 Posted May 4, 2011 Just tried it with my bridge cutter and it worked great Share this post Link to post Share on other sites