Jokerdesigns 3 Posted July 30, 2023 Not sure whats going on here just replaced magenta and yellow head , head2 but seem to have a blur on blk and cyan is this head now need replace as well or somthing diffrent black seems to be a little messy as not crisp and overall print grainy any help be fantastic thoughts please Share this post Link to post Share on other sites
slice&dice 2,450 Posted July 30, 2023 My immediate thought is to have a professional Roland-certified techician come and check out your equipment. Share this post Link to post Share on other sites
Jokerdesigns 3 Posted July 30, 2023 That bad you think ? Share this post Link to post Share on other sites
slice&dice 2,450 Posted July 30, 2023 It's not good. There's a glitch in the matrix over there, I would say. Share this post Link to post Share on other sites
Jokerdesigns 3 Posted July 30, 2023 Picking up main board and servo board up tomorrow maybe ill swap them out see what happens then Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 5, 2023 Did all of you alignment grid look good when you ran that? I always spent more time on alignment than changing the heads 1 Share this post Link to post Share on other sites
Jokerdesigns 3 Posted August 17, 2023 Yes found problem after decicded to change the head was encoder gave it a good clean all back and running again 3 Share this post Link to post Share on other sites
haumana 1,220 Posted August 18, 2023 Thanks for posting your update. 1 Share this post Link to post Share on other sites
