winchester 0 Posted January 29, 2019 I have a Graphtec 6000 40 plus and its been working fine until now all of a sudden its gone crazy cutting all over the place. I attached a picture to show what its doing... Share this post Link to post Share on other sites
bikemike 711 Posted January 29, 2019 Only on that file or all files you send. Post the file you are trying to cut so we can have a look at it. Share this post Link to post Share on other sites
winchester 0 Posted January 29, 2019 Its on any file I try to cut, I use Adobe Illustrator CC with CM4, Ive used these same files many of times before with no problem Share this post Link to post Share on other sites
darcshadow 1,627 Posted January 29, 2019 Weird that it keeps going back to that corner, but it kind of looks like your blade is not picking up. When you turn the cutter on, does the blade lift up? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 29, 2019 Is the carriage head staying down the whole time that it is cutting. How is the blade depth set? This is the correct way. Have you tried factory default reset? Hold down the UP arrow while turning on the power button. . To start with, you should set your blade depth correctly, by taking the blade holder out of the machine, and firmly cut across a piece of scrap vinyl, you will be cutting. You should only be cutting the vinyl and barely a mark on wax paper backing, Adjust blade to get there, Then put the blade holder back in machine, and use the force of the machine to get there, same results, only cutting the vinyl and barely a mark in wax paper backing. You should just barely see and feel the blade tip out of the blade holder. Share this post Link to post Share on other sites