jderry1978 16 Posted April 14, 2016 ok, last few questions. where can I get the assembly instructions for Titan 3 stand? Also does the stand only use one media roller? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 14, 2016 no it should have 2 rollers - hard for the vinyl roll to sit on one. if you only received one I would call support tomorrow Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 14, 2016 Here is the stand set up. should be the same as Titan 11. You use 2 rollers. http://www.uscuttersupport.com/downloads/vinyl-cutters/titan-guide/TITAN_Stand_Guide.pdf Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 14, 2016 no it should have 2 rollers - hard for the vinyl roll to sit on one. if you only received one I would call support tomorrow LOL haven't you seen those pictures where newbies run the roller THRU the roll core? 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 14, 2016 LOL haven't you seen those pictures where newbies run the roller THRU the roll core? too many times then wonder why they have a roll of vinyl unrolled on the floor Share this post Link to post Share on other sites
jderry1978 16 Posted April 14, 2016 yeah I have. Lol.I noticed though it came with 2 core holders like the HP L260 uses to hold media on spindle. So I wasn't sure if that is how the Titan 3 was, since Uscutter states the 68" model is designed specifically to work with digital media. Would help if they had instructions or video or pdf for the T3 68" stand assembly. Share this post Link to post Share on other sites
jderry1978 16 Posted April 14, 2016 Actually I finally just found this photo. Apparently it does only have 1 roller! )Actually I finally just found this photo. Apparently it does only have 1 roller! ) Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 14, 2016 weird - I went to the product page and it showed 2 - that would be a pia to put that thru every roll I changed - all my printers and cutters have had 2 rollers for a quick change - must be another "special" design on the big cutters.next question do you have the 15" spaced pressure rollers like someone just found on the 54" version or does it have a couple spaced closer on one side? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 14, 2016 I humbly stand corrected again Share this post Link to post Share on other sites