Clutch831 0 Posted October 22, 2015 So when I get ready to cut and Asks for the Registration Marks , My laser on the Cutter does not come on. Am I missing a setting or this should be automatic? Just Purchased a Refurbed 25" LaserPoint 2 Cutter last week. Not sure if the same problem. But when I hit Enter on my Cutter on the "on" Icon, the Laser does turn on while the Cutter goes flying to the left and get jams (Keeps trying to go left and doesnt stop making noise). Share this post Link to post Share on other sites
info@thirtymarketing.com 0 Posted October 26, 2015 I am having the same issue with my new SC plotter. Hopefully someone has the answer as this is very frustrating the laser won't turn on to set the reg marks. I have searched around but can not find an answer. Share this post Link to post Share on other sites
Kemo56 0 Posted November 18, 2015 Hello ... Hope this solves your problem... Share this post Link to post Share on other sites
GraphxNMore 282 Posted November 18, 2015 The laser will not automatically come on on the Sc, not sure about the LP2. Share this post Link to post Share on other sites